Setting up subs w/o NPs? (Ion)

I'm sure this is simple, but I can't for the life of me figure it out (or remember it). I've searched the Ion manual.

I'm creating submasters on my Ion with 1 20-channel fader wing. I have two VL1100 TSD's, and I can't seem to set up the subs so that they don't include NP info for the VLs. Even when I was sure I'd done it, later that NP info seemed to creep back into the sub. Weird.

How can I "clean up" the subs so that they don't have the VL NP data in them?

Thanks in advance for any help!

Parents

Tripp3 over 12 years ago

Wow, thanks so much for the good feedback so quickly! What a supportive community.

I'll go look at the board ASAP. Thanks again!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
luke.delwiche over 12 years ago in reply to Tripp3

Another approach would be to only "touch" the level (not the non-intensity parameters) and then use [Record Only].
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Anne Valentino over 12 years ago in reply to luke.delwiche

Or if you are doing a series of these, you could place a filter on intensity.

:-)

a
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Anne Valentino over 12 years ago in reply to luke.delwiche

Or if you are doing a series of these, you could place a filter on intensity.

:-)

a
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data