iRFR connection

Hello all,

I have recently purchased an iPhone 4 and downloaded the iRFR app to work with my space's Ion. I had some issues with initial setup but after going through previous forum posts I'm connected to the router I needed and the app is reading the signal from the board fine in the tests. However, as soon as I go to actually connect to the board, it immediately tells me "No Connection, Connection failed, Connection refused." Has anybody else dealt with this problem before and know how to fix it?

0 ueliriegg over 12 years ago

i'm working with the aRFR but i think you should double-check that you have no typos in the console name aka password
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 bkeith2 over 12 years ago in reply to ueliriegg

Could be the name, also make sure the ability to connect to RFR is active in Desk settings and also turned on in the boot up settings.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Hans.Hinrichsen over 12 years ago

Make sure that the IP address in setup is the IP address of the console (you can find this in the shell or About with a clear command line) and that the IP address doesn't match what your phone has. (Every now and then, we run across a case where the phone was manually entered to have the same IP, and then the app would try to connect to the phone itself.)

Otherwise, definitely re-check the password. If it is the "OEM-random numbers and letters" name, feel free to change it to something a bit more easy to spell. You can find that in the Shell under General.

[edited by: Hans.Hinrichsen at 11:11 AM (GMT -6) on Mon, Jul 1 2013]
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel