Select channel level in all the cues

Hi Juan,

You are on the correct lines. I blind you need to use select Active when you have all the cues selected so only the fixtures that are on will get 10% added to them.

Here is the commands you need.

Blind

Cue 1 Thru [Enter]

Select Active @ + 10 [Enter}

Tom

At the moment you can't add a plus percentage and not affect 0% values.

The work around to this is (if your +% is set to 10%)

Cue 1 Thru Enter

Ch X +% (this will add 10% to 0 values as well).

Ch X @ 10 {Replace With} 0 Enter

It is on the list to add a syntax which doesn't affect 0 values but I'm 99% it hasn't been added yet.

Nick

Another option would be: limit the output of the channel in the patch

If you want a true 10% on all values, do what is suggested. If you want it 10%brighter than what it was you can go to blind, cue 1 thru enter, channel @/110enter. That should bring it 10% brighter, so if at 90 to 99 if at 80 to 88 etc. Not positive it works, but worth a try.

Thanks Nick,

That´s a very good solution. Nice and quick to modify levels in all the cues.

Take care.

I'll speak to Anne, this has been on the list for a long time. I'll see if we can get this bumped up and added to the 2.3 release.

Has this been solved? We're very curious - we cannot find any way to do it STILL!

What are you trying to do, as the answers above were ways of achieving what was being asked?  So it feels like you may have a different question/problem?

I guess we're looking for a way to select all non-zero values of a channel in spreadsheet to modify them in other ways than just up or down ten percent/points. Obviously if we are just raising ten percent, we can definately use the above solutions, but it doesn't work if we're just trying to select all non-zeros to (for example) put them all at the same level or change other attributes - not just raise by a percentage. So just looking for a way to "Select Active" for a single channel across a range of cues.

Chan 1 SelectActive @ +10 Enter

So just to clarify this. Cue 1 thru enter chan 1 thru 6 selectactive @+10 would select all cues with chan 1thru 6 that are above 0 and increase them 10% and leave the cues with 0 at 0?

correct

in Blind....