Issues with existing profiles

Clay Paky Alpha Spot 1500 Vector VL C: I can't get the Gobo wheel 1 to individually rotate the gobos- even when in the correct mode, and once I get to the Gobo wheel 2, the entire wheel is off by 1 gobo (gobo 1 does nothing, 2 loads 1, 3 loads 2, etc. until the last [open] is the final gobo in the wheel) also having difficulties with edge adjust, etc. I suspect the profile is off since it is more than just one attribute that is off. http://www.claypaky.it/media/documents/AlphaSpotHPE1500_Manual_Rev.0_(10.10)_EN.pdf Channel/DMX map starts on pg 24.

From what I remember: the Gobo being off by 1 is already written up. It only happens if you have Open selected when you switch to rotating. It's only a display problem...

From what I remember: the Gobo being off by 1 is already written up. It only happens if you have Open selected when you switch to rotating. It's only a display problem...