2.2 getting direct selects in CIA and display issue

Hi Andrew,

Since the Virtual Controls went away, I can offer a workaround for you -

If you can get by without the physical DS module in the top of the right internal display (for now) you can create the same layout by creating a 2 Row Layout within your new Virtual Workspace. 

In each row, select the DS Controls Option. 

Then click the 1x/2x button in each Layout row and it will reduce the groups of 5x5 tiles down to 1 row of 2.

You will notice that when you expand the CIA, it does squeeze the two rows down, but restores them when you close it again.

Currently if you try to put a physical DS Module into the top right section of Eos, the app does not move the tab down, like the left side does and Eos doesn't remember its last state when you remove the module.  SCR 27713 has been written up to address this.

Also, SCR 27717 was written up to address the show file text and macro information getting cut off.

Thanks!

Hi Andrew,

Since the Virtual Controls went away, I can offer a workaround for you -

If you can get by without the physical DS module in the top of the right internal display (for now) you can create the same layout by creating a 2 Row Layout within your new Virtual Workspace. 

In each row, select the DS Controls Option. 

Then click the 1x/2x button in each Layout row and it will reduce the groups of 5x5 tiles down to 1 row of 2.

You will notice that when you expand the CIA, it does squeeze the two rows down, but restores them when you close it again.

Currently if you try to put a physical DS Module into the top right section of Eos, the app does not move the tab down, like the left side does and Eos doesn't remember its last state when you remove the module.  SCR 27713 has been written up to address this.

Also, SCR 27717 was written up to address the show file text and macro information getting cut off.

Thanks!