Wysiwyg connected but still not working

Hello all,

 

I´ve been trying to connect my gio to wysiwyg.

Connecting on sACN wysiwyg says console is connected, but no lights are coming up.

On EDMX it won´t connect at all.

IP-settings seem to be alright, as i can ping the PC from the console (and back).

EDMX V4 is allowed, on the console it´s beeing sent and set as standard.

No Firewall, program is working fine with Trankstechnik NTX.

any ideas?

 

thx,

Tina.

Parents
  • Hi Tina,

    The status shown on WYSIWYG is misleading as it will show 'Connected' or 'Receiving' even if the console is turned off!

    I recently connected Gio to WYSIWYG, but could only get it to work using the sACN device in WYG, and not via EDMX.

    Do you have a configuration similar to the attached screenshot for your sACN connection?

  • BTW, you could also use a sACN Viewer to confirm that your PC is receiving sACN from the Gio: http://sacnview.sourceforge.net/

    There a couple of other resources that I found when going through this myself - though these are mainly to do with EDMX (which I never did get working) rather than sACN, but may have useful info regarding NICs, etc..

    https://www.etcconnect.com/Support/Articles/Connecting-Congo-and-Eos-Family-Consoles-to-a-Visualiser.aspx
    http://www.cast-soft.com/wysiwyg/tip/view/connecting-to-edmx-networks
Reply
  • BTW, you could also use a sACN Viewer to confirm that your PC is receiving sACN from the Gio: http://sacnview.sourceforge.net/

    There a couple of other resources that I found when going through this myself - though these are mainly to do with EDMX (which I never did get working) rather than sACN, but may have useful info regarding NICs, etc..

    https://www.etcconnect.com/Support/Articles/Connecting-Congo-and-Eos-Family-Consoles-to-a-Visualiser.aspx
    http://www.cast-soft.com/wysiwyg/tip/view/connecting-to-edmx-networks
Children
Related