• State Not Answered
  • Date
    lightingdesignmike
  • Date
  • Replies 3 replies
  • Subscribers 184 subscribers
  • Views 3129 views
  • Users 0 members are here

Rate and Size on submasters, screens

Hi All,

This may have been asked already but without going through the whole forum I wondered if someone could help

I've seen in the 2.5 version and later there is a properties page for submasters

I want to busk on a show and I see you can set an effect on the first fader in properties and then you can set 2 more up so I set these to rate and size, but I do not see these when I put the sub master onto a fader. I just want to have my FX on for example submaster 1 and submaster 2 as size and submaster 3 as rate. Is this possible?

also there used to be a screen page that had channels and cue stack (but showed about 4 cues), now the page has only the cue you are on. I do not want to split the screen in 2 as I have a lot of fixtures and want to see all of them.

is there a way that I can create it like before 2.5 

 

Thanks in advance

Parents
  • 0
    You don't want sub 1 with the effect and sub 2 and 3 with rate and size but rather you want faders 1 to 3 to belong together to a certain submaster. In tab 36 which is the fader config tab you can change properties of the faders, among other stuff you can choose x1, x2, X3. Choose X3 to make the two next faders reference the first and then set their sliders to the properties you want.

    Are you aware that if you split the screen you can then change the size of the different segments?
  • 0 in reply to ueliriegg
    Hi

    Thank you for your response, I will give it a go tomorrow when I get back on the desk and let you know if I have any problems.

    As for screen I'm aware of the split screen and size but just was handy before when it was on one tab, as with split screen you lose some of the screen due to the master ribbon etc and still only get 2 cues on my playback

    just while I think of it is the solo working now as I'm aware it wasn't before
Reply
  • 0 in reply to ueliriegg
    Hi

    Thank you for your response, I will give it a go tomorrow when I get back on the desk and let you know if I have any problems.

    As for screen I'm aware of the split screen and size but just was handy before when it was on one tab, as with split screen you lose some of the screen due to the master ribbon etc and still only get 2 cues on my playback

    just while I think of it is the solo working now as I'm aware it wasn't before
Children
Related

www.etcconnect.com