My Inno Spot Elite lights go black when they move, then come back up once the unit has stoped moving. How can I fix this?

The "Position Blink" parameter may be set to "Blink". Set it to "Off" and see if that fixes the issue.

Also check the "Position MSpeed" next to the Position Blink Parameter. If it is something other than 0 try setting it to 0.

Thank you Todd! I will try that as soon as I can and let you know if it works.

Thanks! I'll try that and let you know if it works! :D

Sorry, this didn't end up working.

I set it to Off, but my problem persists.

It would be helpful for troubleshooting if you can run the cues with "About" open and the channel selected.
Select the "Current Values" button to see what the console is sending to the light. That way you can figure out if it is the console somehow fading the light out or if it is the fixture doing it internally.

I have not used these lights, so I'm just going off the information in the manual and EOS profile.

Don’t have a console, or Nomad, in front of me to confirm this, so this all is a bit of a guess.

Looking at the manual, it looks like the fixture might have a ‘Blackout w Pan/Tilt movement’ button within lamp controls. Could this have gotten set accidentally??

There should be another button that is ‘No Blackout w Pan/Tilt movement’. If the above was done, hitting this button should solve your problem.

These buttons will undoubtedly be abbreviated, but should be recognizable.

Hope this helps.
Jeff