Patching RDM using Ion

Hi all

I'm trying to patch a Lustr D60 XTI with my Ion.

I have updated it to the latest firmware (2.6.4) so as far as my understanding goes, plugging in the 5 pin universe 2 should be RDM enabled (I have ticked RDM enabled in the shell)

When I go to patch, I make sure to go to 'Device list' > Rdm > Device discovery > enabled

But nothing shows up. The back of this fixture doesn't have a screen so I can't even address the thing with RDM.

The RDM in yellow at the top of the Patch tab (tab 12 patch (RDM)) has 2 rectangular boxes that are empty. I feel like they should be ticked or green?

Can anyone help? I feel like I'm banging my head against a brick wall.

Many thanks

Kate

0 ueliriegg over 7 years ago

Two things:
What is the connection from the DMX port of the ion to the fixture? Any dmx splitters?
And what version of the ion do you have? Is there a VGA connector at the back, are there two network connectors, are there 4 DMX ports? Depending on hardware you might need to make a firmware update for your console's DMX ports.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Kate L AA over 7 years ago in reply to ueliriegg

No splitters it's 5 pin DMX to cat5.

Not sure which version it is. it's running 2.6 which I thought would include the firmware update. Is there a separate one? Only one cat5 network I can see, one VGA, a handful of USBs, and two DVI connectors at the back. Does this help?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 ueliriegg over 7 years ago in reply to Kate L AA

Keep Tab pressed, type 99 and release Tab. This opens diagnostic tab. On the bottom right hand side (maybe you have to scroll down) there should be a list of currently loaded firmware versions. What number is listed for the I/O card?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel