EOS Programming wing and problems with RDM

Are you going through an Opto / Splitter?
Is that Opto RDM Compliant?

Is the Gadget using the exact same wiring configuration?

eeehhhh !!!!   [:O]
I do not understand absolutely nothing. 
After many  [C][C]       try something unusual ... and voila! It works ... but I do not understand it.
It turns out that the ports marked as "Console", are not those of the console .... but then what is its meaning?

 

[:#][:#][:#]                                                             [:#] [:#][:#]

eeehhhh !!!!   [:O]
I do not understand absolutely nothing. 
After many  [C][C]       try something unusual ... and voila! It works ... but I do not understand it.
It turns out that the ports marked as "Console", are not those of the console .... but then what is its meaning?

 

[:#][:#][:#]                                                             [:#] [:#][:#]

So you plugged the Gadget in and assigned its port 1 as the same DMX output as the console's port 1 DMX output.
I don't know the Gadget well, but it looks like it superseded control from the console.

not....
Actually, I was activating ports 1-2 that are marked as a console (?) .... thinking that they were those of the Programming wing.
However, the Dmx-Rdm ports of the programming wing are marked (identified) as Gadget [serial no. --------]
Programming wing only has two DMX-RDM ports.
I imagine that the four ports (Console) DMX-RDM, correspond to Ion, Gio..etc.
For me it is confusing, hence the mistake made.

Summary; confusion with the identification of ports ... my fault. [+o(]

No worries.
Learning something new is always a good day.