Signcomplex CWW36-RGB3 Profile

Keith T said:

Just wondering if there is a better profile to use that would give us control over the individual cells.

From the limited description on the website that controller is 4CH so the answer is going to be no you wont be able to control the individual cells as 3 are going to be the RGB values and the 4th might be some macro or strobe setting (you can always patch it with a profile like  Generic LED RGBW and then play with the W value and see if does anything interesting for you.

There is not a DMX chart on the site and even if there was often on the Chinese generic fixtures the dmx chart is for different firmware to what you actually have, so it might not have helped much anyway.

Assuming all 10 fixtures are on the same controller then If you wanted to control each of the 10 fixtures separately you could get more of those controllers and plug them in each LED enclosure separately and then you would be able to run a sequence down the wall.  (Of course it might be there are already more controllers installed but the installers just set them to the same address if so that's an easy fix)

Keith T said:

Just wondering if there is a better profile to use that would give us control over the individual cells.

From the limited description on the website that controller is 4CH so the answer is going to be no you wont be able to control the individual cells as 3 are going to be the RGB values and the 4th might be some macro or strobe setting (you can always patch it with a profile like  Generic LED RGBW and then play with the W value and see if does anything interesting for you.

There is not a DMX chart on the site and even if there was often on the Chinese generic fixtures the dmx chart is for different firmware to what you actually have, so it might not have helped much anyway.

Assuming all 10 fixtures are on the same controller then If you wanted to control each of the 10 fixtures separately you could get more of those controllers and plug them in each LED enclosure separately and then you would be able to run a sequence down the wall.  (Of course it might be there are already more controllers installed but the installers just set them to the same address if so that's an easy fix)

Hi Mike

Thanks for your reply. I have control over each fixture but was hoping to improve the capabilities of the fixtures. Ill change the profile to Generic LED RGBW like you suggest and see what happens. Otherwise it might be time to suggest an upgrade to the fixtures we have.

Thank again for your help

Keith