Signcomplex CWW36-RGB3 Profile

Hello, Keith:

In order to best determine the answer to your question we would need to see the fixture manual.  Unfortunately I am unable to find that from the link your provided or a google search.  Do you have access to a manual you could share?

Thank you.

Hi 

Thanks for getting back to me.

I don't have one but have emailed Signcomplex to see if they can send me one.

Thanks

Keith

Hi

Signcomplex sent me through a .pdf I have attached below, is this information in this any use to you?

Keith

CREE wall washer neutral manual.pdf

There is no dmx chart for the controller in that document as far as I can see,  in fact it looks like its just the manual for the actual LED enclosure and there is a separate controller that you connect up to the fixture that supplies the power to the seperate Red Green Blue circuits.

It the controller bit that;s supplying the power to those led's that someone would need the manual for.  Although if you've got it working with a generic RGB profile that's probably in reality all you need.

Mike is correct- in order to create a profile we need the DMX control layout.  I'm sorry to say this document does not contain that information.

Hi 

Thanks for getting back to me, this is not my main area of expertise so please forgive my lack of knowledge. The DMX unit controlling the fixtures is a LTECH LT-840-5A I cant find an exact match on their website but the closest one is this.

http://www.ltechonline.com/html/en/products/DMX-RDM-Controller/DMX-PWM-CV-type/LT-840-6A.html 

Im presuming there isn't much that can be done with this?

Keith 

Keith T said:

Just wondering if there is a better profile to use that would give us control over the individual cells.

From the limited description on the website that controller is 4CH so the answer is going to be no you wont be able to control the individual cells as 3 are going to be the RGB values and the 4th might be some macro or strobe setting (you can always patch it with a profile like  Generic LED RGBW and then play with the W value and see if does anything interesting for you.

There is not a DMX chart on the site and even if there was often on the Chinese generic fixtures the dmx chart is for different firmware to what you actually have, so it might not have helped much anyway.

Assuming all 10 fixtures are on the same controller then If you wanted to control each of the 10 fixtures separately you could get more of those controllers and plug them in each LED enclosure separately and then you would be able to run a sequence down the wall.  (Of course it might be there are already more controllers installed but the installers just set them to the same address if so that's an easy fix)

Hi Keith:

Based on this info I was able to find a manual here:  https://www.rapidonline.com/pdf/56-1059.pdf

It looks like Generic LED RBGW 8b may be the way to go- it seems the 4th channel is white.  That being said it doesn't have any layout other than that for subsequent cells or anything of that nature- just those 4 channels.

Thank you.

Hi Mike

Thanks for your reply. I have control over each fixture but was hoping to improve the capabilities of the fixtures. Ill change the profile to Generic LED RGBW like you suggest and see what happens. Otherwise it might be time to suggest an upgrade to the fixtures we have.

Thank again for your help

Keith 

Hi Sara

Thanks for getting back to me on this. We will stick with the generic profile.

Keith