• State Not Answered
  • Date
    WillSwep
  • Date
  • Replies 2 replies
  • Subscribers 185 subscribers
  • Views 1462 views
  • Users 0 members are here

Mixing LEDS on Subs

Hi,

I want to be able to have 3 subs: Red, Green, Blue so that I can mix the colours from subs.

I've looked into this and I know that I need to selective record the subs or go into blind and @ enter the other values to remove them. So far I've tried both of these and it still doesn't work, I think it may have something to do with the pre-set of the fixtures.

I was wondering if its possible to do a similar thing in live for removing the values as it is in blind with @ enter.

If not how do I make a new home pre-set for the fixtures?

Thanks

Will Swep

Parents
  • 0

    If it helps any, I've found the easiest way to do old school colour mixing on EOS is to run your RGB subs as Inhibitives.

    This requires a 4th sub (that does not need to be on Faders) with all values at Full.

    (Keeping in mind you can control subs from the command line... [Sub] (30) [At] [Full] [Enter]  works.)

    This way you don't get into any trouble with subs and NP data.

Reply
  • 0

    If it helps any, I've found the easiest way to do old school colour mixing on EOS is to run your RGB subs as Inhibitives.

    This requires a 4th sub (that does not need to be on Faders) with all values at Full.

    (Keeping in mind you can control subs from the command line... [Sub] (30) [At] [Full] [Enter]  works.)

    This way you don't get into any trouble with subs and NP data.

Children
No Data
Related

www.etcconnect.com