Shutdown Macro Not Running On Nomad

I have the same issue. When I assign a macro 702 as shutdown macro in setup, it doesn’t run when I exit the software. 

My syntax is:

GOTO CUE OUT Enter

ClearCmd Sneak Enter

It may require a macro_wait to allow the command to finish.

Do you suggest putting a macro wait command before or after my syntax?i think the console doesn’t even start to fire the macro at all actually. 

I think Ueli is correct about Exit not being the same as Shutdown.

On the console I have observed issues with some commands like Lamp Off, GotoQ, and Sneak where the manual time is still counting down but the macro has finished. The fix has been to add a macro_wait after executing the commands to keep the macro from exiting until the manual time events have concluded.

I think Ueli is correct about Exit not being the same as Shutdown.

On the console I have observed issues with some commands like Lamp Off, GotoQ, and Sneak where the manual time is still counting down but the macro has finished. The fix has been to add a macro_wait after executing the commands to keep the macro from exiting until the manual time events have concluded.