• State Suggested Answer
  • Date
    turingtest2
  • Date
  • Replies 9 replies
  • Answers 1 answer
  • Subscribers 187 subscribers
  • Views 4005 views
  • Users 0 members are here

Part of cyc missing in Mind The Gap viz in new EOS Family Learning Series

While waiting on Augment3d I thought I'd have another go at trying to get a test install of Capture working when I noticed the updated training materials with the standalone Mind The Gap vizualizer included and was pleasantly surprised to find that it connected. However for one reason or another I find that only the stage left most column of the cyc is active. Is this an oversight, some limitation because Nomad is running without any dongle, some local performance issue, or have I overlooked some configuration instructions?

Parents
  • 0

    Hey,

    Apologies if this has already been tried, but this has worked for me when connecting Capture with Nomad.

    With the one of the training showfiles loaded, you’ll notice in Patch that the channels are talking to DMX, sACN, and ArtNet. There has always been an issue (for me) when sACN and ArtNet where on at the same time. 

    When I started the training I noticed that a side light was stuck at full without control. I instantly knew there was that issue in patch. Sure enough i found all three (sACN,DMX,ArtNet) were on. So while in patch, I selected Ch1 Thru 362 changed it to ArtNet only. Within a second the sidelight went out and everything worked as is should. If ArtNet doesn’t work, try sACN.

    hope this helps!

  • 0 in reply to JohnnyFocus

    the training showfile isn't patched with DMX, sACN, ArtNet. it's patched with Default. so if your nomad/eos settings in the shell have e.g. ArtNet and sACN set to default, then you will get multiple protocols output, but it's rather because of your settings than because of the showfile.

Reply Children
Related

www.etcconnect.com