Element 2 patching LED fixture

ETC's convention of noting buttons to press: [hard keys, i.e. actual buttons] {softkeys, i.e. somewhere on screen}

[Patch] [Patch]

[3][0][1] [Thru] [3][1][2] {Type} {Search} ETC Colorsource Par
(i chose 301 thru 312 but you should number them with channel numbers you can easily remember)

this will show you a selection of different fixtures and modes. there are two colorsource par models, the "regular" and the DeepBlue (DB), they're labeled at the back). and each of those had different modes. i suggest using Direct mode. so click that

so now you told your console which channel numbers you wanna use and which manufacturere, model and mode those fixtures are.

now for the address: [At] [2] [/] [1] [Enter]
this will use the first address in second universe for the first of the twelve CS pars. it needs 6 addresses, so the next one will have address 7. the console does that for you.

[Live]

now you need to go to your fixtures (in real life, go to the fixtures and use the menu at the back) and set them to the same mode and the respective addresses.

So if my power is connected to say 52 on the grid .. i would patch patch 52 first then address .  Thanks for help

if the lamp power is from dimmer/non-dim 52, yes.  give D52 a channel, and then [PARK] that channel ON so it always supplies power. (that's 1/52 in the console, same as your conventionals).

then program the lamp as 1, 7, 13,  . . . . (as per Ueliriegg above)

then program the console with your choice of channels @ 2/1, 2/7, 2/13 etc. (second universe).

if the lamp power is from dimmer/non-dim 52, yes.  give D52 a channel, and then [PARK] that channel ON so it always supplies power. (that's 1/52 in the console, same as your conventionals).

then program the lamp as 1, 7, 13,  . . . . (as per Ueliriegg above)

then program the console with your choice of channels @ 2/1, 2/7, 2/13 etc. (second universe).