Flash opposite Button in Fader config

Further information from the Hog manual regarding the "flash fader opposite" function:

Flashes the command assigned to the fader to either its highest or lowest level depending on the position of the fader.

If the fader level is at 50% or higher then flash level is 0%. If the fader level is below 50% then the flash level is100%.

-Todd

For a channel selection, [Shift] [Full] and [Shift] [Out] has those flash functions, but it isn't a built-in feature on submasters. If you have one of your submaster buttons assigned to Group Select, then you could use that to select them and then use those functions, or you could write macros for each of those functions with the group selection and assign them to the buttons.

As far as I know, there's no context-specific way of achieving this with one button on Eos consoles.

For a channel selection, [Shift] [Full] and [Shift] [Out] has those flash functions, but it isn't a built-in feature on submasters. If you have one of your submaster buttons assigned to Group Select, then you could use that to select them and then use those functions, or you could write macros for each of those functions with the group selection and assign them to the buttons.

As far as I know, there's no context-specific way of achieving this with one button on Eos consoles.

Thank you, Cody. I guessed it...