Running Gio@5 on v3.0. DMX universe 1, from console to splitter to I-cue PSU.
Today I noticed my I-cues are not panning / Tilting correctly. When I give them negative focus values they jitter at the 0 degree position instead of moving past "centre". (In A3d they continue to move correctly)
I have moved my other fixtures with focus control (Elation 5R Platinums) and they are moving correctly in real life and in A3D.
I have tried reverting to v2.9 and the I-cues are still not moving into their negative values.
Back in v3.0 again, I have updated the fixture profile, the problem still persists.
I have swapped my I-cue PSU, problem still persists.
I have tried doing a reset at the I-cue, restoring mode and dmx channel after reset. Still no fix.
At this point I am wondering if there is a problem at the desk, or in the data stream being sent to the I-cues. Has anyone else had this or a similar problem?
Thanks,
Elliot
