• Date
    alexsunny123
  • Date
  • Replies 2 replies
  • Subscribers 188 subscribers
  • Views 624 views
  • Users 0 members are here

+/-% buttons and discrete timing ?.

Hello,

I know that by default the +/- % buttons are set to +/-10%.  I have set them to +/-5% because that's the way I like it. However, when the operator uses them, the command line still shows: +10% or -10%.

My operator somehow put a 30 second discrete time on a single channel (dimmer). I tried to change it to a 3 count to match the rest of the que by typing Channel xxx Intensity Time 3 but that didn't work. Nor does the manual say how to delete this timing. Perhaps she specified a parameter other than intensity (if that's possible on a dimmer channel). Is there a way to see what parameter was set to 30 sec? None of the que's times were showing as a 30 count.

thanks

alexsunny

Parents

  • don't forget that also a discrete Delay will cause the t indicator. depending on what your operator set it's not enough to Chan X Time Enter, you will also have to do Chan X Delay Enter. and then like Seth mentioned you'll have to update the cue (unless you were removing the discrete times in Blind).

Reply

  • don't forget that also a discrete Delay will cause the t indicator. depending on what your operator set it's not enough to Chan X Time Enter, you will also have to do Chan X Delay Enter. and then like Seth mentioned you'll have to update the cue (unless you were removing the discrete times in Blind).

Children
No Data
Related

www.etcconnect.com