ETC ColorSource Relay

Just opened a box of three new ETC ColorSource (Wired) relays. Luckily I see that these are addressed as 512 by default. I've never used RDM. We have several hard wired opto-isolators in the line going back 25 years! So definitely not two way. Question: If I really wanted to change the address could I plug a temp DMX cable out of the ELE2 and directly into the relay to program it? And once a new address was programmed I am assuming that address will 'hold' when not in use! I.E. Does RDM have to police its targets all the time? I'm totally RDM illiterate, at this time

Parents

ueliriegg over 3 years ago

this will work. to use the direct cable from console to the relay you might need to activate RDM in the element's shell.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

ueliriegg over 3 years ago

this will work. to use the direct cable from console to the relay you might need to activate RDM in the element's shell.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

Robert452 over 3 years ago in reply to ueliriegg

Excellent. And, will the Relay 'hold' the DMX address when I go out and hang it on a bar with a one way DMX line?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
ueliriegg over 3 years ago in reply to Robert452

yes
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Robert452 over 3 years ago in reply to ueliriegg

A final question before I slink off down into the light pit: Using some old 4 outlet SCR dimmer boxes to cut power (not a 'bright' idea) I patched them to 97-100 (we have a 96 Sensor rack) and put them into a sub for the operator to turn them on and off.

Just to double check. With our new ETC Relays the instructions tell me they will auto turn on and off when a DMX is present or not. Should I simplify things then by(using the default) park 512 at 100% thereby relieving our operators another job?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel