Applying An Effect in Blind Preset That Fails Results in an Unremovable Effect

Question

New show 
 Patch an LED RGB Generic 
 Blind 
 Preset 1 
 Chan 1 Effect 914 
 Effect fails to apply, but is still listed as being active in the preset 
 ESD shows no channels running the FX 
 Trying to stop the FX results in "Error: Effect Not Running" 
 
 Still on 3.0.1 Beta Build 23

Matt Pumplin · Accepted Answer

I see this in v2.9.2.8 as well. Will get it written up. 
 If you delete Chan 1, the Effect goes away. Bit of a sledge-hammer to the problem, though.... 
 In this case, you could enable Virtual HSB, add and remove the effect, then disable Virtual HSB. Less of a sledge-hammer....

eos moderator · Answer

This was fixed in 3.2.0.

Applying An Effect in Blind Preset That Fails Results in an Unremovable Effect

Top Replies