When i turn on the Element Console 1 channel turns on at full. how do i turn this off so that no lights are on until needed??
When i turn on the Element Console 1 channel turns on at full. how do i turn this off so that no lights are on until needed??
What font color does the level of this channel have?
red
Ok, that means it's manual, so its source isn't a cue.
Are you saying that if you *** down the board with that channel off and you turn on the console, the channel is now on? Or could it be that the console was switched off with that channel still turned on?
So i turn all the channels/ cues off prior to shutting down. when I power on the board everything is off except 1 channel at full. there are no sliders up or anything.
You might have a startup macro that causes this.
At this point, it might be simplest for you to take logs from the console and email them to eos@etcconnect.com (following these directions: Retrieving or Saving Log Files from Eos Family Consoles - Electronic Theatre Controls Inc) If you do, please be sure to reference this Community Forum thread.
You might have a startup macro that causes this.
At this point, it might be simplest for you to take logs from the console and email them to eos@etcconnect.com (following these directions: Retrieving or Saving Log Files from Eos Family Consoles - Electronic Theatre Controls Inc) If you do, please be sure to reference this Community Forum thread.
www.etcconnect.com