Is it possible to do this on a cue by cue basis? It seems that entering a curve in the cue only affects intensity and not NPs.
Is it possible to do this on a cue by cue basis? It seems that entering a curve in the cue only affects intensity and not NPs.
Via Cue Parts yes it is possible.
If you create a Part 2 and apply a curve to that part it will affect all parameters in that part. (Works Parts 2 and up)
If you want independent curves for Pan and Tilt then you will need a 3 part cue.
Ah, so with no parts it will only affect Intensity?
Ah, so with no parts it will only affect Intensity?
Correct!
Manual link and text for some better wording
When applied to a cue, the “percent completion” of the cue is determined by applying the curve’s output level as the percent completion for all fade calculations. For single-part cues, the calculation applies only to intensity. For multipart cues, however, the curve applies to all parameters in the part.
www.etcconnect.com