ShutterPair only works with Hardware-encoder

Question

Hello, 
 i try to focus some Shutter-Blades while using the function {Pair AC}, {Pair BD}, {Pair All}. 
 If i am not able to have a Hardware-Encoder -> a Desk, than i would use a couple of ways. 
 1. open a Movinglight Control 2. Use a Mouse and drag my shutter in the Encoder-Display 3. Enter hard values by selecting one Encoder 
 All of the 3 Listed above, will only work for one Shutter, even if i have selected one of the "Pair"-Modes. Beeing on a Desk or on Nomad does not matter. it is still the same outcome. 
 Tested on: 
 Nomad v3.1.3b8 Gio v3.1.3b8 
 
 --- 
 Is this on purpose? 
 
 yours thilda

Matt Pumplin · Accepted Answer

These controls were added to Eos in v2.5.0, about six years ago, so it is hard to say if this was specifically on purpose. 
 There is an open SCR about adding the Shutter Controls to the ML Controls page. At that point, I would guess that mouse controls would work with the Pairing. 
 [EOS-40388] Add the Graphical Shutter tools to ML controls 
 I will add your notes as specific requests to that.

Shutter>Pair only works with Hardware-encoder

Top Replies