• Date
    felixgeiger
  • Date
  • Replies 3 replies
  • Subscribers 185 subscribers
  • Views 3867 views
  • Users 0 members are here

select single channels inside a group

hello everybody

 

in the past i (as an operator) or a designer wanted to ask for the "front light, 1st zone, 2nd light from the left" without knowing the channel number. but i would know that 1st zone of the front light was Group 11. so it would have been handy to type Group 11/2 At Full, where 2 would be the 2nd channel in this group. it doesn't necessarily have to be a / , it could be a . but since you can have a goup 11.1 i think that would be confusing..

 

any thoughts?

Felix

 

ps: i hope i didn't miss an essential part of the manual where you describe how to do exactly what i want to do... and if i have made a complete fool out of myself, then please point me to the page of the manual ;-)

Parents

  • Actually, you didn't miss anything in the manual about this - as the function you are looking for doesn't quite exist.  You can use next/last to navigate through the channels in you group, but..... :-)

    We've had several suggestions along the lines you've described above.  And we (the team)  like the idea a lot.  As such, its currently "on the list."

    Thanks much!

    a

     



    [edited by: Anne Valentino at 3:27 AM (GMT -6) on Thu, Feb 25 2010]
Reply

  • Actually, you didn't miss anything in the manual about this - as the function you are looking for doesn't quite exist.  You can use next/last to navigate through the channels in you group, but..... :-)

    We've had several suggestions along the lines you've described above.  And we (the team)  like the idea a lot.  As such, its currently "on the list."

    Thanks much!

    a

     



    [edited by: Anne Valentino at 3:27 AM (GMT -6) on Thu, Feb 25 2010]
Children
Related

www.etcconnect.com