3.2b291 on pc, recording a show with flexi FILTER ON

i'm not aware of Flexi filters. are you refering to View Channels?

Wrong Forum?
The Post's Heading states the current Beta, right?

by flexi filter i meant the filters you choose in CIA when keepin flexi button pushed.

by the way, when i put those filters on or off,  eos doesn't indicate there has been a change in the show, does it mean filters are dependant of the device  and not of the show? one thing i get wrong here.

not sure it depends of which eos version is used, as i said: first time i use those filters. If this is specific to the beta, yes, i have to move this post, but can't say.

Technicaly Flexi is a state. Can also be called Flexi-View.

It is recordable in a Snapshot.
Because it goes into snapshots and is a viewing tool, it can be 'per user' based.

passa said:

i want to get every day the same specific filters on, but for now i see that if i turn Filter Off and reload the show, it doesn't recall Filter on and it doesn't remember which filters were on.

Than your Desk is doing the right thing. Because you turned them OFF before powering down.
If you like to have a specific view recalled with the startup of your Desk, record a shnapshot and write it in a Macro.
The Macro can than be called on Startup:

Setup->System->System->System Startup Macro

-----

Filter on the other hand are: Viewport Filter(Parameter Filter), Record Filter

Viewportfilter:
   The Filter her should be put in: "Filter" (later at the end)
   can help you to see not all Parameter in you Live-View.
   You can press and hold the Parameter-button (left of a internal screen) or hold down the Data-button. While holding down,
   you can select/deselect in the CIA Fixture Parameters that you like/not like to see.
--> they record into Snapshots, while they are NOT controlable under the checkbox of Filter 

Record Filter:
   Can be set in the CIA or by holding down the Filter-Button left to a Internal Screen.
   If you have Record Filter active, you (maybe) will see some gray N's written some paramters in Live View.
   Further more they are marked in you CIA-Screen in the lower left as active.
   Those Filters interact with the record command.
--> They can be recorded into Shnapshots, but need to be activated explicitly with the 'Filters-Checkbox'.
      If i record Record Filter in snapshoots, i make sure that nothing else is in this Snapshoot that alters the Viewport.

Second Picture...

thanks for the teaching, Mathilda. i got the difference between viewport filters and record filter, i just missed the record filter option in snapshot recording menu, that will help.

Since then, i use cue list filters, which is perfect to me, even more accurate than record filters from cia.

ah, i think you mean the filters that you apply by pressind Data, not when pressing Flexi. right?