New to Programming generic fixture

If to be used as a theatrical fixture (rather than blinky effects fixture) you could use this:

with this as range config for Intens:

You won't have access to the strobe function (you can however use an intensity effect to make the fixture strobe), nor to the effect parameter at the end. I still added it as Dummy parameter to make patching easier, but it will not show up anywhere on your controls or cues.

If however you want to use those effects in channel 6 that would probably a parameter called Effect Macros with a range config that would look something like this (I just did the first few):

Does this help?

Using this profile with the fixtures results in intermittent strobe effect and no ability to control color output on the fixtures. these are definitely some of the oddest fixtures I have run across.

If they strob with the Settings from above, something isn't right.

And no color controll could be because the color adjustment is looked and only possible if you set your CH1 to 240-255.

But that is indeed a strange Fixture.
And it is even stranger to only have the DMX-Chart.

If they strob with the Settings from above, something isn't right.

And no color controll could be because the color adjustment is looked and only possible if you set your CH1 to 240-255.

But that is indeed a strange Fixture.
And it is even stranger to only have the DMX-Chart.