ML Control Mouse Sensitivity

have your tryed to use the Pan/Tilt "encoders" that are next to the square grid?

you can use them with your mouse wheel or simply tip on the roller.

Tried both methods but the sensitivity is just too corse to be useful. We can click on the top or bottom of the “rollers” but it takes multiple clicks to change position 1 degree. Very slow to use this method. I wonder if changing to a trackpad instead of mouse would improve things?

Tried both methods but the sensitivity is just too corse to be useful. We can click on the top or bottom of the “rollers” but it takes multiple clicks to change position 1 degree. Very slow to use this method. I wonder if changing to a trackpad instead of mouse would improve things?

Two things to check:

• Just to make sure the manipulation of the virtual encoders ("rollers") are fully understood: You click and hold (statically at the same position, rather than moving it with your mouse). The closer you are to the center line (blue in the screenshot) the slower the encoder (and your parameter) moves.
  
• Depending on the fixture and fixture mode you're using, more or less precise control is possible. Would you mind sharing which exact fixture profile you're using?

Thank you.

Thanks, I do understand how the Virtual encoders work with the mouse.

We have both Intimidator Spot 255 IRC 13ch AND Intimidator Spot 375Z IRC 15ch...

I wish dragging the "dot" on the square grid in ML worked better but a very small movement makes the spot pan/tilt too fast.

Appreciate your help...