EOS to trigger Resolume

Question

Anyone know how to setup EOS to trigger Resolume in the background Tried OSC with RX 7000 and TX 7000 I tried to execute a CUE with /composition/layers/1/clips/1/connect 
 also tested a Submaster with same syntax / execute 
 
 also tried /cue/%1/start 
 
 I also tired the DMX option with the same setup running ETC Nomad and a Gadget2 setup to LED Batons 
 starting to feel defeated tried everything 
 
 don't think its possible to do OSC Eos > Qlab > resolume using a network switch 10.101.1.1 255.255.0.0 53000 53000 8000 for ETC Resolume only communicates on 7000 I could be wrong on that

shaneey · Accepted Answer

Hi just wanted to follow up with response to this . I got It working after. My was issue within Resolume the Syntex wasn't correct

eos moderator · Answer

First issue: you want to have different parts for Tx and Rx. 
 Also, did you enter a OSC UDP Tx IP Address?

eos moderator · Answer

The windows IPv4 settings are from the computer running Nomad? And you're sending to the computer with the settings in the screenshot below (mint colored OSC Preferences title across the top)? 
 Summary: 
 
 Nomad: IP 10.101.1.1 subnet mask 255.255.0.0 sending to 10.101.1.2 Rx 7000 Tx 7001 
 Resolume: IP 10.101.1.1 subnet mask unknown sending to 10.101.1.2 Rx 7000 Tx 7001 
 
 If that summary is correct, your problems are as follows: 
 
 you have two computers with the same IP address (unless you run Nomad and Resolume on the same computer) 
 you're sending not to the other program's IP address 
 the Rx port of one application needs to match the Tx port of the other application.

EOS to trigger Resolume

Top Replies