Macro Editing Softkey Anomaly

As a rule of thumb we recommend learning a macro first and then editing if necessary, rather than writing a macro from scratch.

In your case you should also be able to use the Lamp Control functionality in patch to do this instead of a macro. It's intended use is sending DMX values to control channels of fixtures, using a timed sequence. Which sounds exactly like what you're trying to do.

As a rule of thumb we recommend learning a macro first and then editing if necessary, rather than writing a macro from scratch.

In your case you should also be able to use the Lamp Control functionality in patch to do this instead of a macro. It's intended use is sending DMX values to control channels of fixtures, using a timed sequence. Which sounds exactly like what you're trying to do.

Ok I see your point. I have never used 'Lamp Control' so this is a good chance to further my education.

This is an urgent job. I've never used LCs. This is what I need:

ML "DJXLF1" is patched to Chan 127 using DMX 2/80 - 91.

We need to put "Full" into DMX 2/91 followed by a "0" four seconds later.

Help appreciated.