que stays at 0.0 sec

Is your Master Fader Pair up all the way?

yhea, im running on nomad i dont really use the master fader pair

can you please make a picture of your Tab 2 when this is happening.

Same problem. The showfile has been imported from a foreing theatre by selective merge.

I’m having the same issue, but it seems to emerge only after cloning in a new fixture. Only way I’ve been able to fix it, was by loading another showfile and then loading the showfile where the bug occurred. Seemed to solve the issue, don’t know why though. 

Can you show a screen shot when the duration hits zero, but before you advance to the next cue... In the PSD does it show the % going from 0 - 100% and the time going from 5 seconds down to zero? 

Cannot upload a screenshot anymore: I followed woopi method and this weird behaviour disappeared. Solved

I’m on tour and after arriving at the next location, it was fixed as well, maybe turning it off and on again worked (and I mean also turning off the power button, not just closing down the software and). So I can’t make a screenshot right now. It only seemed to occur after cloning a fixture (copy only show). 

It works as a normal running cue, it turns red, counts down the timing and gives a percentage. But when it arrives at the end of cue (time at zero, percentage at 100%), it stays red. Also, Hang cue won’t go. 

I’m on tour and after arriving at the next location, it was fixed as well, maybe turning it off and on again worked (and I mean also turning off the power button, not just closing down the software and). So I can’t make a screenshot right now. It only seemed to occur after cloning a fixture (copy only show). 

It works as a normal running cue, it turns red, counts down the timing and gives a percentage. But when it arrives at the end of cue (time at zero, percentage at 100%), it stays red. Also, Hang cue won’t go.