Multi console power on

Running Ion 1.9, and RVI.

Finally have a chance to use the Remote Power On/Off, and I found out that I must manually power on the RVI the first time I hook it up to the Ion, so I can manually select the Ion the RVI needs to find (we have 2 Ions in the building, the RVI swaps back and forth between venues)).  Once the link is established, the Remote On works fine.

I would ask that the Remote Off NOT power off the entire system.  I'd like to only turn off the RVI, but not the Ion.

Cheers

Andrew Riter

Andrew, we are working on a adding a higher level of granularity to the shut down procedure.  Will be in a future build.

Thanks,

a

I know this is an old thread but it answered some of my question but poses another one.

Is there anything in the works that would allow a remote power on of the ION board itself?  I would love if during techs I could turn everything on/off from the RVI unit on the tech table instead of having to climb up to the booth at the end of each night.

And is there anything in the works where one can do remote power on of the ION board from the aRFR or iRFR?  Again it would be very helpful if when I got to the theater I could turn the board on through the app over the network without having to climb up to the booth and then back down to channel check everything.

I know this is an old thread but it answered some of my question but poses another one.

Is there anything in the works that would allow a remote power on of the ION board itself?  I would love if during techs I could turn everything on/off from the RVI unit on the tech table instead of having to climb up to the booth at the end of each night.

And is there anything in the works where one can do remote power on of the ION board from the aRFR or iRFR?  Again it would be very helpful if when I got to the theater I could turn the board on through the app over the network without having to climb up to the booth and then back down to channel check everything.

You can send a Wake on Lan message to the Ion to turn it on.

On another note but related is there anything in the works to allow the Power off Macro to fire for the multiconsole shutdown procedure?

See one of the posts above: Wake-on-LAN doesn't work with the consoles, only RVI's and RPU's.

-Todd