Encoder 1 Not Working... HELP

Afternoon Chaps,

This morning after much scroller calibration, we mananged to knacker the number one encoder! We were able to lift the wheel right off, it seems that the little grub screw has managed to work its way loose. We are going to swap the console out at some point soon... but for the time being I am at a loss to know what we ought to do about all of our NIPS on the first encoder (shutters, colours, beam shifters, etc...).

Anyone got any bright ideas?

Chaosbob over 14 years ago

Macros! and the +/-% keys.

I've run into this before and what I did was select the NIP in the CIA and use the +/-% keys, (which I have set to 05%), but then also made some macros that are: [@] [+] 01 [Enter] and [@] [+] 10 [Enter] (and their - counterparts).

The only drag is that you must reselect the NIP each time before you hit the +/-%... but it works in a pinch.

Hope that Helps

-M
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Anonymous over 14 years ago

Unfortunately, there isn't much you can do except use the ML controls to access those parameters. If you haven't (I assume you have), get a hold of tech services asap.

-Doc

[edited by: doc_blume at 9:47 AM (GMT -6) on Fri, Oct 22 2010]
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
luke.delwiche over 14 years ago

Hi Vic, where are you? Give me a call, 07711006053.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
victoria.brennan over 14 years ago in reply to luke.delwiche

Thank you all for your responses. We're going to go with the ML controls solution for the time being (I can't wait!) and have a man with a teeny alan key on his way!

Thanks again,

Vic
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel