In the begining of December i re-programmed our New Nutcracker. i recorded Snapshot 11 as follows;
record snapshot 11 enter
then i tapped on Monitors, Subs, Direct Selects.
then i believe i hit OK.
at this afternoon Matinee, i was in Q126 (Q127 next), my direct selects were not liked i wanted them. i then proceded to push "Snapshot 11 enter" No problem until Q127 Go. When i hit GO CUE 0.5 executed. Apparently when you record a Snapshot it holds the PENDING CUE.... Does any one else see a problem with this? Thanks
