We run and Eos, RPU, Sensor system and our normal configuration is RPU as Master/Primary and Eos as backup with device descovery enabled for Sensor feedback, etc. The Eos was accidentally switched to Client mode recently and every channel patched to a Sensor dimmer was showing an error on the screen. If I went to About and tried to check the errors there were none. After a reboot I couldn't even look at sensor data. When I switched the console back to Backup all the errors went away and everything was functioning as normal. I wish I could say which user the RPU was setup as but I wasn't able to check before leaving for the night.
Is this a glitch or is there some communication cross-talk that is occuring here?
