Is it possible to make a flash solo on the ION fader wing

Hi,

Sub 1 Edit
channel 1 @ FF

now you can flash with the button...
is this what do you mean???

I think Dario means that when a flash button is pressed, all other intensities are inhibited until the button is released. I don't recall this being an available function, though of course I am probably wrong!

David.

David,  yes that is it.

Dario

Solo is not currently supported as an option from the sub buttons.

Thanks!

a

I hope you will in the future be available and this function.

Thanks,

Dario

While not the best method, this seemed to work offline.

Make your Sub LTP.  In the sub, take all of the other intensity channels in your show and give them a hard 0.

Voila, an improv Solo bump button.

Of course if you had wanted to use this sub as an additive sub during your show as well, then it doesn't quite work for that, but....

travisres said:

Make your Sub LTP.  In the sub, take all of the other intensity channels in your show and give them a hard 0.

That would get rid of any manual channels, so if you're trying to use this in the middle of cuing you'd get hosed.

You can use [Highlight]  & [RemDim]. This will take the selected channel to FL (and open white) and take everything else to 0. Hitting [Highlight] again will restore.

-M

Ah, Very good point. And here I was thinking I was being crafty. Oh well. 

Thanks Marc,

Ah, Very good point. And here I was thinking I was being crafty. Oh well. 

Thanks Marc,