• Date
    usesafesets
  • Date
  • Replies 1 reply
  • Subscribers 183 subscribers
  • Views 1578 views
  • Users 0 members are here

HL group selection

When working in a Highlight/Lowlight state it would be nice to select a group. And then select a channel in that group with out loosing the original group selection. 

 

I have also seen that on the display when I am Nexting and Lasting through a group with a lot of channels in it, 100+, that every so often the entire group will flash to HL and then revert to the individual channel selection. Is this normal? 

Parents

  • Hey Ben.  We are adding syntax in 2.0 that allows you to select a group and specify a channel within that group all in the same command line - to avoid the "group all flash to highlight" upon initial selection.  

    If you select through a channel list/group, next and last specify individual channels to work with, but the entire selection is maintained.  You can get back into the entire selection at any time by pressing [Select Last]. 

    Hope that helps.

    a

     

Reply

  • Hey Ben.  We are adding syntax in 2.0 that allows you to select a group and specify a channel within that group all in the same command line - to avoid the "group all flash to highlight" upon initial selection.  

    If you select through a channel list/group, next and last specify individual channels to work with, but the entire selection is maintained.  You can get back into the entire selection at any time by pressing [Select Last]. 

    Hope that helps.

    a

     

Children
No Data
Related

www.etcconnect.com