Sneaking threw pallets/Manual Cue fade

Lukas, there are two ways to step through cues quickly.  You can set the fader mode to Manual Master.  This triggers cues from the movement of the faders from home (either zero or full) and follows the progress of the potentiometers.  Or you can disable timing on the fader (Timing Disable + Load).  This allows advancing the cue list via go, but it disregards cue timing.

To sneak to palettes, if you are using the command line:

(Channel Selection / Recall From for the entire content) (Palette Selection) (Sneak) (desired time) Enter

If you are using the direct selects, enter sneak and the required time (if not using default sneak time) prior to pressing the required direct select.

Hope that helps.

a

Did you manage to load your cuelists onto your Faders?

I believe the syntax is:

[Cue][x]/[Enter][Load} - Then press the two buttons together underneath the fader you would like to assign the cue list to.

You can also assign cue lists by going into Displays-Setup-Fader Config, and assigning the fader to a playlist.

Once you've done that you will be able to press the bottom button of the two below the fader. This will act as a Go button and the top one as your Stop/Back.

Yes, i did know this

the only thing is to fade the next cue manual.

Well, console is in the truck, so i'll try it just before the show.

hope i'll make is :-D

Thanks a lot!

Lukas