• Date
    JTalley
  • Date
  • Replies 4 replies
  • Subscribers 184 subscribers
  • Views 2942 views
  • Users 0 members are here

Cue List intensity master strangeness

hey all!  I am having 2 separate strangness with cue stacks with the fader set as an intensity master.

First stack is different front light systems  they are all set to be intensity masters.  Once I hit go(first time after board is turned on only) I have to bring the fader all the way up and back down before it will work at all.  Is this right?

Second strangeness is a list of atomic strobes with different fx and rate for each step in the cue.  The fader controls the intensity's again.  When I hit go (only for the first time I hit go on the stack once again) this time the stack assumes it is at full even if the fader is down.  I have to pull up and back down to have it turn off. 

For both of these stacks if I go out of the cue and try again they act normally.  Any ideas?

Parents

  • see my list of posts "ION multiple cue lists on faders" a few above yours.  Your issues are similar and different.  Actually looks like your strobe issue is the same.

    My situation is when I tap the bottom bump (go) with the fader down it turns on intensity full, then I grab it with the fader, bring it to zero, tap the top bump (gotocueout i think) in order to release that cue list and once I do that for every cue list on every fader then when I tap the bottom bump all it does is set the cue in black.  I can then control the intensity with the faders for the rest of the show until the console is shut down and rebooted.  It then resets it back and I have to go through those steps in all my cue lists all over again.

Reply

  • see my list of posts "ION multiple cue lists on faders" a few above yours.  Your issues are similar and different.  Actually looks like your strobe issue is the same.

    My situation is when I tap the bottom bump (go) with the fader down it turns on intensity full, then I grab it with the fader, bring it to zero, tap the top bump (gotocueout i think) in order to release that cue list and once I do that for every cue list on every fader then when I tap the bottom bump all it does is set the cue in black.  I can then control the intensity with the faders for the rest of the show until the console is shut down and rebooted.  It then resets it back and I have to go through those steps in all my cue lists all over again.

Children
Related

www.etcconnect.com