GLP impression X4

their website says this:

Eos currently thinks Pan is 660° and tilt is 300°

does it work if you go to the fixture editor and change the pan range to -311.5 to 311.5 and the tilt range to -147.5 to 147.5?

ueliriegg said:

-147.5 to 147.5?

With these values, the position was also not correct.
I adjusted the minimum and maximum values to match tilt +/-90 ° physically with A3d.

Thanks for the tip! So I immediately adjusted the values of other fixtures.

ueliriegg said:

-147.5 to 147.5?

With these values, the position was also not correct.
I adjusted the minimum and maximum values to match tilt +/-90 ° physically with A3d.

Thanks for the tip! So I immediately adjusted the values of other fixtures.

what were the actual values you used for the x4?

That's where I need to check. I'll check it out tomorrow.

Tilt -126 > 126