Hello;I need to make a macro which raises a fader and if I run it again, lower the fader.
Does anyone know if this is possible?
Eos-Family? "Fader 1/5 At 30 Enter" will move the 5th fader on fader page 1 to 30%
I need the same macro to be able to raise a fader and then that same macro can lower it.
This is so that ETC Response Analog I/O can handle a fader with the same input.
what type of record target is assigned to the fader? a sub?
A preset with house light.
you can change the timing behavior of the fader to Hold and your macro (it needs to be learnt!) is simply pressing the bump button.
I made it but the problem is the fader don't work only the information. I would need the fader work too.
that will only work with multiple macros. you can always target the same macro, but that macro -after doing its job- will replace itself with another macro.
Thanks so much Ueliriegg!!!
I will try it.