LED Lustr+ flicker

Greetings!

I've got some borrowed Source Four LED Lustr+ ellipsoidals with 36° EDLTs, just opened up the boxes to set them up. One, so far, has a wicked flicker that didn't show up immediately: perhaps only 30 minutes into burning it. Using Quick Setup 'Stage': testing the fixture on Cobalt on Congo with Device Template "S4 LED Lustr+ HSI Strobe." Seems to program fine; is my configuration mismatched? Absent that I'm assuming it's an issue with the unit itself.

Planning to call tech support Monday anyway, but if anyone's seen this I'd love to hear where to start. Totally unfamiliar fixture for me, looking forward to playing with it.

*Edited to add--after a closer look at my device template, I suspect that missing 2 channels including the fan control probably has something to do with this. Sneaking suspicion.

[edited by: Anne S at 9:30 AM (GMT -6) on Sat, Feb 15 2014]

Parents

0 ueliriegg over 10 years ago

hi anne

i think your suspicion is correct. there are 41 different modes for a S4 Lustr+ ... when you set the fixture to Quick Setup Stage, you would have to use that as a profile as well. isn't there a template "QS Stage" in cobalt?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 ueliriegg over 10 years ago

hi anne

i think your suspicion is correct. there are 41 different modes for a S4 Lustr+ ... when you set the fixture to Quick Setup Stage, you would have to use that as a profile as well. isn't there a template "QS Stage" in cobalt?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 bkeith2 over 10 years ago in reply to ueliriegg

I have these units set in stage mode with RDM. Though using a Gio, they are reported as HSI +7 Strobe Fan and use 15 channels. Stage has 7 channels of colour. I think you are talking to the strobe on the wrong channel based on how the unit has been setup.

[edited by: bkeith2 at 12:20 AM (GMT -6) on Sun, Feb 16 2014]
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel