Special Hex Key for LED Array on Selador Vivid-R Classic

HI Lightingguy1,

Depending on what you zoomed into the silver holes are just part of the PCB board and not hex.

There are 6 screws that attach the boards, and then they are attached with a heat transfer double adhesive tape underneath that is a bity tricky to get the board off, but it is doable.

What are you actually trying to do/fix/repair, scrape, save, borrow, beg steal from?

So I’m attempting to swap out the LED Array board. But I’m not seeing said screws?

I see...you have a later Diode board revision.  The one I had to look at is REV A.  There is a white sticker on that board that has a REV of the circuit board.  Can you tell me what it is?

I still believe it's likely just the double adhesive that is keeping the board in place once you have the other connection points removed.  I'll see if I can track down a newer unit that has the same board tomorrow.

Dow this help?

Yep that helped.  So you have these 6 "posts that attached to the board and go through to the base.


39/6 is a STOF 4-40 x 9/16 M-F 1/4-HX SS

Yep that helped.  So you have these 6 "posts that attached to the board and go through to the base.


39/6 is a STOF 4-40 x 9/16 M-F 1/4-HX SS