Hello All,
Can someone direct me to the proper tool need to unscrew the LED array from the fixture body? Please see photo attached for reference.
I’ve tried all of my hex key sizes, but they’re all still to big. Any specific info would be greatly appreciated!
HI Lightingguy1,
Depending on what you zoomed into the silver holes are just part of the PCB board and not hex.
There are 6 screws that attach the boards, and then they are attached with a heat transfer double adhesive tape underneath that is a bity tricky to get the board off, but it is doable.
What are you actually trying to do/fix/repair, scrape, save, borrow, beg steal from?
HI Lightingguy1,
Depending on what you zoomed into the silver holes are just part of the PCB board and not hex.
There are 6 screws that attach the boards, and then they are attached with a heat transfer double adhesive tape underneath that is a bity tricky to get the board off, but it is doable.
What are you actually trying to do/fix/repair, scrape, save, borrow, beg steal from?
So I’m attempting to swap out the LED Array board. But I’m not seeing said screws?
Dow this help?
Yep that helped. So you have these 6 "posts that attached to the board and go through to the base.
39/6 is a STOF 4-40 x 9/16 M-F 1/4-HX SS
I take that back - #SUCCESS !!
Please tell me you guys stop using that pasty stuff to glue down the boards…
