Sensor CEM Classic - Hold Last Look

I have a 46 channel Sensor Touring rack with the CEM classic.

I want to be able so set the Hold Last Look, to hold until I reset the dimmers. I've been able to change the settings on the rack to hold for 999; is there a way to make it hold longer?

Also the pins in the patch bay fit loosely, and slide out easy. Any tips on how to split the pins to make them fit more snug?

Finally can the CEM classic connect to a computer the way that the CEM+ can?

Parents

mmeskill over 12 years ago

Setting the data loss fade time to zero (0) will hold the look for an infinitive amount of time in v3.1. I know there was a version of code (maybe 3.0?) that this did not work.

Might I ask what you are looking to do this?

Sincerely,

Mike
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
willbb123 over 12 years ago in reply to mmeskill

How do I tell what software version the CEM is running?

We do rock shows, and after the show I bring up some pars as work lights, then unplug dmx and strike the lighting console.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

willbb123 over 12 years ago in reply to mmeskill

How do I tell what software version the CEM is running?

We do rock shows, and after the show I bring up some pars as work lights, then unplug dmx and strike the lighting console.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

mmeskill over 12 years ago in reply to willbb123

You can see the current SW by hitting 'reset' and then watching the LCD screen.

You can try recording a backup look that is the worklights and then play that from the CEM....But this is a bit of an inconvenience if you are in a front of house position as you would need to go to where the rack is located....or have someone backstage 'play' the backup look for you :-)
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel