Sensor CEM Classic - Hold Last Look

Setting the data loss fade time to zero (0) will hold the look for an infinitive amount of time in v3.1. I know there was a version of code (maybe 3.0?) that this did not work.

Might I ask what you are looking to do this?

Sincerely,

Mike  

How do I tell what software version the CEM is running?

We do rock shows, and after the show I bring up some pars as work lights, then unplug dmx and strike the lighting console. 

You can see the current SW by hitting 'reset' and then watching the LCD screen.

You can try recording a backup look that is the worklights and then play that from the CEM....But this is a bit of an inconvenience if you are in a front of house position as you would need to go to where the rack is located....or have someone backstage 'play' the backup look for you :-)

You can see the current SW by hitting 'reset' and then watching the LCD screen.

You can try recording a backup look that is the worklights and then play that from the CEM....But this is a bit of an inconvenience if you are in a front of house position as you would need to go to where the rack is located....or have someone backstage 'play' the backup look for you :-)