Focus points are required to bring in conventional P/T data from VW correct?

Hi Cory Pattak,

The orientation of the fixture should come in as drawn from Vectorworks via the plug-in. If you used focus points for the orientation, then those points do need to be visible in the export for the reference data to be included and used.

But what if you aren't using focus points, and you just enter raw data in the P/T field, such as 45° and 45°. Should that translate into orientation data in A3d? for me, it does not, the lights are pointing straight down. 

It does not. You would want to use a focus point or the fixture's location and rotational data:

or focus the fixture in Augment3d after import.

copy. ok thanks.

so I guess maybe this is a feature request then. Using the xyz to "focus" a light in VW is unintuitive because it ignores all clamp/yoke logic...it's much more intuitive to use the Pan/Tilt fields.  When you use a Focus Point, there is no data in the xyz rotation fields, so clearly Augmented is able to read that P/T data. Perhaps in the future, Augmented could read that data without needing to have the Focus Points? 

Currently, clamp/yoke logic is ignored for conventionals in Augment3d (already on the list). Adding Pan/Tilt support without focus points would be a good feature request to make here: Eos Family Feature Requests - Eos Family Consoles - ETC - Community

Currently, clamp/yoke logic is ignored for conventionals in Augment3d (already on the list). Adding Pan/Tilt support without focus points would be a good feature request to make here: Eos Family Feature Requests - Eos Family Consoles - ETC - Community