The visualizer available from the ETC website isn't working using 2 computers.

Hi John,

I had a similar problem with the Capture file for Mind The Gap.  I found a setting in the buried in the file which told my laptop which NIC to use when I had both my wired and WiFi in operation.  I had my wired in a 10.101.XXX.XXX connected to a switch.  The WiFi was in the 192.168.XXX.XXX.

The other thing to try is turning off the WiFi on the laptop when you start the Capture file to see if it autoselects the wired connection.

If you can't find the setting, let me know, and I will try to recreate how I found it.

Good luck,

JP

Hi John,

I had a similar problem with the Capture file for Mind The Gap.  I found a setting in the buried in the file which told my laptop which NIC to use when I had both my wired and WiFi in operation.  I had my wired in a 10.101.XXX.XXX connected to a switch.  The WiFi was in the 192.168.XXX.XXX.

The other thing to try is turning off the WiFi on the laptop when you start the Capture file to see if it autoselects the wired connection.

If you can't find the setting, let me know, and I will try to recreate how I found it.

Good luck,

JP

I got it working. I think what may have happened was when tech support told me to turn off WiFi, I disconnected from the wireless network but didn't turn off WiFi.

Today, I turned off WiFi before starting Capture and it didn't work and it froze my system. I rebooted and all of a sudden it started working. I tried getting it to not work again just to see what the problem was but I couldn't get it to not work.

Thanks for your help.

Incidentally, I'm pretty sure I met you when we were shooting Hit The Floor at the Cerritos Performing Arts center.

Yes, you did.  I recognized your user name from other posts on the forum.

Hello JP,

I would be interested in knowing where you found these settings. I have been experiencing the sometimes working sometimes not Mind the Gap program with my system. The only thing I have found which sometimes works is to start the computer before I start the ETC console, but this does not work half of the time.