Closing tab 1

I completly agree with this

Additionaly sometimes I`ld like to close the PSD Tab too.

For example I like to have just a MS on the left,and DS on the right Monitor.

I completly agree with this

Additionaly sometimes I`ld like to close the PSD Tab too.

For example I like to have just a MS on the left,and DS on the right Monitor.

Howdy! For the time being, we are going to retain Tabs 1 & 2 as always open, primarily in service of the displays being able to quickly go to a known state, regardless of what system you happen to walk up to.

Don't forget that [Tab] & [Page Left/Right] moves tabs between frames & monitors. I do agree that we could make improvements to more quickly getting a tab to a specific frame on a specific monitor, without duplicating it (including across workspaces). I'll write those up for future development.

Thanks for the feedback.
~n~

Hi,

Thanks for your answer. It is not exactly what I asked though. If another instance of tab 1 is open, I would like it to be possible to close all but the last instance. Now you can only close the ones that are not the very first one. It should be the other way around: you should be able to close instances of tab 1, until there is only one left.

Given that there are fixed and immutable FX that are on board, there could just as easily be a snapshot 901 that could put the console in a known state if required. then the rest of the time, the users could define for themselves what they'd like to see.