Custom fixtures parameters settings weird intensity functional

Hi Guys,

Any  replies on this post to allow me setup these Chinese not referred  fixtures.

Thanks 

Oumar

Dear Oumar,

it is quite hard to help you without testing with the unit itself.

And the Ranges in your Intensity are nice to have a look at.

The Fixture is quite something different : )

What jumped to my eye was the Pan and Tilt. They most likely are 16bit.

You can change that by clicking at there DMX-Addr. in the DMX coloumn.

And the Movementspeed is set up Virtual in your Fixture. In the Manual, it is DMX Ch5.

yours

thilda

Dear Thilda

thanks for your response i already tried 16 and 8 bits in the pan and tilt , The issue here is the intensity in DMX channel 6 of the fixture that had range as per the manual and i cannot set it right ..

The behaviour of the intensity is weird when i am @ out the light is on and when @full its a strobe...

regards,

Oumar

Dear Thilda

thanks for your response i already tried 16 and 8 bits in the pan and tilt , The issue here is the intensity in DMX channel 6 of the fixture that had range as per the manual and i cannot set it right ..

The behaviour of the intensity is weird when i am @ out the light is on and when @full its a strobe...

regards,

Oumar